KẾT QUẢ THỬ NGHIỆM HỆ THỐNG ĐẢM BẢO KHÍ KHÔ ĐỒNG THỜI CHO CÁC MÁY BAY SU-22 TẠI HỌC VIỆN PHÒNG KHÔNG - KHÔNG QUÂN
Viện Độ bền Nhiệt đới, Trung tâm Nhiệt đới Việt - Nga
Số 63 Nguyễn Văn Huyên, Nghĩa Đô, Cầu Giấy, Hà Nội
Số điện thoại: 0988155589; Email: Hahuuson@gmail.com
Nội dung chính của bài viết
Tóm tắt
DEHUMIDIFICATION SYSTEM FOR SEPARATE OBJECTS
In this work, the working efficiency of the dehumidification system TKK-3 has been evaluated for six cabins of aircraft at the same time. The design of the dehumidification system, the experimental plan, and the results of the humidity assessment of the cabins are presented. Moreover, corrosion testing for metal specimens has been performed. The results show that the system has worked effectively and stably during the test period. The relative humidity of cabins using a dry air-blowing system is lower than 60%RH. After three months of testing, corrosion was not observed for metal specimens using a dehumidification system. Therefore, the system TKK-3 is suitable for the long-term storage of separate objects, such as aircraft and tanks.
Từ khóa
Dehumidification system, relative humidity, corrosion, aircraft
Chi tiết bài viết
Tài liệu tham khảo
2. Báo cáo năm của đề tài NCKH “Nghiên cứu ảnh hưởng của các yếu tố khí hậu nhiệt đới lên trạng thái kỹ thuật của thiết bị bay và thiết bị mặt đất của Quân chủng Phòng không-Không quân”. Mã số Ecolan T-2.1, Hà Nội, 2018.
3. Báo cáo năm của đề tài NCKH “Nghiên cứu ảnh hưởng của các yếu tố khí hậu nhiệt đới lên trạng thái kỹ thuật của thiết bị bay và thiết bị mặt đất của Quân chủng Phòng không-Không quân”. Mã số Ecolan T-2.1, Hà Nội, 2019.
4. ГОСТ 9014:1978, Bременная противокоррозионная защита изделий, Общие требования.
5. Håkan Schweitz, Use of dehumidification to reduce preventive and corrective maintenance of aircraft due to corrosion, RTO-MP-AVT-144, 2007.
6. ГОСТ 9.909:1986, Mеталлы, сплавы, покрытия металлические и неметаллические неорганические, Методы испытаний на климатических испытательных станциях
7. ISO 8565:2011, Atmospheric corrosion testing - General requirements